Dynamic view filters

For many dynamic views, view filters can be set at the bottom of the view. Enter a comma separated list of packages into the combo box and hit enter to dynamically filter the view.
All dynamic views with a view filter box at the bottom share the same current view filter. To reset the view filter and show the entire content of the view again, click on [Reset view filters] in the lower right corner of the view. The combo box holds view filters that have been entered during the current session. Selecting an entry from the combo box enables the view filter immediately.

View filters have an effect similar to the inclusive filters that are set for the session. These are configured in the profiling settings dialog and are not adjustable while the session is active. However, the active filter sets of the session strongly influence the speed and memory consumption of the profiled application while the view filters don't. It is therefore advisable to activate as many filter sets as possible in the call tree collection options and use the view filters for dynamic drill down only.