Heap walker view helper dialog

The view helper dialog is displayed each time when a new object is created. New object sets are created by choosing objects in the heapwalker views and clicking on the [Use selected] buttons.
The view helper dialog is intended to assist you in choosing the view that is most interesting for the new object set. You can switch to desired view by selecting the corresponding radio button and closing the dialog with the [OK] button. On the right hand side of the dialog a short description of the selected view is displayed.

The view helper dialog automatically suggest a view based on the contents of the new object set.

To discard the new object set you can leave the dialog with the [Cancel] button. You will then be returned to the previous heap walker view.

You can suppress this dialog by clicking the Do not show this dialog again checkbox at the bottom of the dialog. In this case the view change to the automatically suggested view will be performed without confirmation.
To show the dialog again at a later time, you can adjust this setting in the heap walker view settings.